When setting up a moteus controller with a new motor, you typically first run the automatic calibration sequence as documented in the reference manual. When your system is working well, that should be all that is necessary to enable moteus to perform accurate FOC based torque control of the motor. Then you can set up basic parameters and tune the position PID control loop. What happens though when the automatic calibration doesn’t work? This post shares the most common failure modes during calibration.

People over in the mjbots discord frequently ask about how to build reliable XT30 cables, so I made a short video describing how I go about it!

While testing some variants and new versions of the power_dist board, I wanted to be able to simulate the types of loads that it experiences with a fully loaded robot. Some things are easy, like this capacitor attached to an XT30 connector:

I also have giant power resistors in a similar form factor:

However, a dumb load resistor isn’t a particularly representative load. Most likely, the loads that a power_dist will drive are active loads with switching regulators. When the output voltage is lower, the current will be correspondingly higher. That is especially important when validating pre-charge behavior, because it means that the current is much higher during the initial pre-charge window than it would be for a pure resistive load.

I’ve been using a relatively inexpensive microscope for SMD soldering work for some time, connected via HDMI to a 24" monitor.

For the price, I’m definitely happy with it, but as I’ve been doing more soldering work, I’ve become less happy with the mounting stand. The arm it mounts to often does not reach far enough to get the optics over the part of the board in question, or the base is too tall or wide to fit under it. If you want to examine something from the side, you have to tip the entire base over. I have resorted to spinning the microscope around and counterbalancing the base with a large weight, which works for some definition of “works” but only improves the reach by a little bit.

I’ve muddled along for a long time soldering with a little Weller WES50. I’ve done a lot of work with it, but given how many SMD boards I’m doing with big ground planes and tiny components, I needed something a bit more capable. Enter the Pace ADS200 from tequipment:

Made in the USA, with 120W of power and a wide range of tip selection it has been an incredible upgrade. All those soldering jobs which were painful before are so much easier, and I don’t even have all the tips I wanted for different jobs yet. I also have the MiniTweez, but don’t yet have the tips that will let me show that off. I’ll try to post some soldering videos in the not too distant future.