Being a switch mode 3 phase motor driver, the moteus controller changes the current flowing through the phases of a motor by rapidly switching the phase terminals between the positive input voltage and the input ground. The control of this switching is denoted “pulse width modulation”, or PWM for short. To date, the rate at which it has switched has been fixed in firmware at 40kHz. As of release 2022-03-12, this can now be altered anywhere between 15kHz and 60kHz to better optimize peak power capability, control bandwidth, maximum speed, and heat generation.

With the r4.8 release of moteus, a not-yet-announced feature was included – the ability to have an off-board primary encoder! It didn’t get announced at the time, because the connectors necessary to populate the board were not obtainable. In fact, that is still the case, but I’ve located a substitute part which works well enough, so here we go!

Theory

The moteus controller uses an absolute magnetic encoder to determine the relationship between the rotor and stator of the motor at each given instant. That allows it to produce torque in the motor at any speed, from standstill to the maximum possible speed. Until now, the only magnetic encoder that was supported is the one mounted to the backside of the board. This is largely acceptable, as moteus is intended to be used in integrated applications.

Now that 64 bit Raspberry Pi OS is a real thing, I finally got around to updating the pi3hat libraries. Now, as of pypi 0.3.20, you can use the pi3hat library to run console only or graphical tview on the most recent Raspberry Pi OS!