To demonstrate the dynamic capability of the full rotation quadruped, I figured I would start by doing some full machine jump tests to a relatively low height, just to show that it was capable.

Thus, I rigged up an open loop script which squatted a small fraction of the available distance, and then powered up at a relatively small fraction of the available maximum speed.  I don’t have the telemetry yet to extrapolate how high this will be able to go at maximum, but I think it should be a fair amount higher.  For now, I want to do some more instrumentation and walking testing (and have more spares) before I manage to break things by jumping really high.

After having used my PocketNC V2-50 for a while just sitting on top of the air compressor, I decided to try and improve its installation a bit.  For one, when the compressor kicked on or off, it would impart a significant vibration to the whole assembly.  Also, I needed a place to hold stock, tools, and intermediate parts.  Here’s a picture of my new setup.

The table isn’t particularly rigid, but at least it is now decoupled from the compressor.  The wire shelving below satisfies my storage requirements for now.

Last time, I had finished physically assembling all the motors for the updated quadruped with legs that can rotate freely 360 degrees.  After the long summer break, I powered up and configured all the servos.  Then, after setting up the gait engine for the new configuration (for which there are still a TODOs when the lateral shoulder offset is non-trivial as in this configuration), I was able to achieve some amount of walking.  Here is one of the first videos I took, without much in the way of tuning or work.  The control is a little wobbly still, but so far there are no signs of any mechanical failures as with the older design.