The first version of the planetary gearbox as 3d printed from Shapeways required a fair amount of post-machining to get all the pieces to fit together.  I wanted to get to a point where I could just order some parts and have a reasonable expectation of them mostly working out of the box.  To make that happen, I’d need to get a better understanding of where the tolerances were coming from.

Understanding the problem

Shapeways provides a fair amount of documentation on the processes and accuracy you can expect generally.  Most of this is detailed in “Design rules and detail resolution for SLS 3D printing”, however the results there have some limitations.  Primarily, they are only applicable to the specific geometries tested.  Shrinkage is qualified as +- 0.15% of the largest dimension, and is likely influenced by the exact printed geometry.  Secondarily, in the documented tests, the designers had full control over the part alignment in the print.  The standard shapeways platform does not allow you to orient parts, you are at the whim of their technicians where the Z axis will end up.